Fits: Elegoo Jupier Series and Peopoly Phenom
Our XTR Flexi Plate is an extra thick spring steel, made with the same high quality, rustproof chromium alloy as our FBSR, providing extra stiffness to resist peeling and bending when printing edge to edge. The Wham Bam Flexi Plate is custom-etched on both sides to provide an exceptional grip for your first layer.
Explore more info on the Flexible Build System for Resin.
Printer Fits:
• Elegoo Jupiter
• Elegoo Jupiter SE
• Peopoly Phenom
Do you have a printer similar to what's listed under Printer Fits or May Fit?
If you have a printer similar to the one described above and believe our solution could work for your printer, please follow our easy instructions on measuring your build plate. Let us know if your printer matches our specifications or is even close! We’d love to hear about it, and you might even receive a discount on Wham Bam® merchandise for your efforts. Click here for more info.
Includes:
1 XTR Flexi Plate - 0.6mm spring steel
**XTR Flexi Plate only, no XTR Magnetic Base included**
Find the complete kit here.
Size: 286 x 166 mm
Full support info can be found on our support page.
Sanding The Flexi Plate for more grip:
You can scuff one side of the Flexi Plate with 400 grit wet dry sandpaper (and clean well with IPA and the fresh paper towel a few times until the paper towel comes away clean) to get more grip.
Need Even More Grip? Try this tip:
If even more grip is needed use 320 or even 220 grit. Keep one side with our original etched surface and the other sanded, you can flip over as needed.
Resin Printing Best Practices with the Wham Bam Flexible Build System
You can wash parts on the Flexi Plate
You can wash parts on the Flexi Plate or remove them from the Flexi Plate and wash parts separately.
Never cure on your Flexi Plate
Never cure parts on the plate to avoid depositing cured resin on the Flexi Plate.
Never leave resin between Flexi Plate and Magnetic Base
Do not leave your Flexi Plate on the Magnetic Base with resin between the two for longer than 2 hours.
Stuck Parts
Large rigid parts will pop off when you flex the Flexi Plate, but smaller supports may stick. For stubborn areas, carefully scrape with a spatula, chisel, or razor blade. If necessary, retouch the surface with 400-grit sandpaper.
Always clean your Flexi Plate & Magnetic Base between Prints
Always clean your Flexi Plate well with isopropyl alcohol and let it dry completely before placing it on the Magnetic Base.
Always Clean your Magnetic Base with isopropyl alcohol and let dry completely before replacing the Flexi Plate.
![C.E. Smith 536800S - Flush Mount Rod Holder - 0 Degree - Swivel - 10.5" Deep [536800S]](https://www.bicyclebag.shop/image/ce-smith-536800s-flush-mount-rod-holder-0-degree-swivel-105quot-deep-536800s_yeN4uQ_300x.webp "C.E. Smith 536800S - Flush Mount Rod Holder - 0 Degree - Swivel - 10.5\" Deep [536800S]")
